How Do You Rescreen A Patio Door

How Do You Rescreen a Patio Door?

Rescreening a patio door is a relatively simple task that can be completed in a few hours. With the right tools and materials, you can save yourself the cost of hiring a professional. Here are the steps on how to rescreen a patio door.

Materials You Will Need:

New screening material
Spline
Spline tool
Utility knife
Screwdriver
Measuring tape

Step 1: Remove the Old Screening

Use a utility knife to cut the spline around the edges of the old screening. Be careful not to cut the frame of the door. Once the spline is cut, you can remove the old screening.

Step 2: Clean the Frame

Use a damp cloth to clean the frame of the door. Remove any dirt or debris that may interfere with the new screening.

Step 3: Measure and Cut the New Screening

Measure the opening of the door and add 2 inches to each side. Cut the new screening to the desired size.

Step 4: Install the New Screening

Place the new screening over the opening of the door. Starting in the center, use the spline tool to insert the spline into the groove around the edges of the frame. Work your way around the door, pulling the screening taut as you go.

Step 5: Trim the Excess Screening

Once the spline is in place, use a utility knife to trim the excess screening around the edges of the door.

Step 6: Reinstall the Door

Reinstall the door into the frame and secure it with screws.

Tips:

Use a sharp utility knife to cut the spline. A dull knife will make it difficult to insert the spline into the groove.
Pull the screening taut as you insert the spline. This will help to prevent the screening from sagging.
Trim the excess screening carefully. If you cut the screening too short, it will not be able to be secured properly.

Rescreening a patio door is a simple task that can be completed in a few hours. By following these steps, you can save yourself the cost of hiring a professional.